Oce TCS500 - Extended Copy Jobs Settings; Original Type Settings for Copies; Scale Settings for Copies

167
Available settings for copy jobs
Extended copy jobs
Available settings for copy jobs
Introduction
The Océ TCS500 provides a lot of settings to manage all your different copy jobs.
These settings are used for extended copy jobs. The following table gives an
overview and a very short description of the available settings. This table is not
complete, because a setting can contain more than one setting. You find a detailed
description of each setting in the on-line help at the Océ Settings Editor. You can
change the default value of a setting that you use very often in the job template at the
Océ Settings Editor.
Available settings for copy jobs
[64]
[64] The available settings for copy jobs, a setting can contain more than one
setting. (1 – 6)
Setting Function
'Original type' Use this setting to define the type of original for your
copy jobs. The defined type influences the quality of
the output. (see ‘'Original type' and background
compensation’ on page 140)
[132]
[132] 'Original type' (example)
'Scale' Use this setting if the size of your output must be
different from the size of your original. (see ‘Scale to
another media size’ on page 178)
[133]
[133] 'Scale' (example)