Oce TCS500 - Optimize Output Quality on Printer; Problem Analysis and Solutions

208 Chapter 8 Ensure the best output quality
Optimize the output quality on the printer
Optimize the output quality
Optimize the output quality on the printer
Introduction
This section describes different methods that you can use to optimize the output
quality on the Océ TCS500 printer.
Problem analysis and solutions
[84]
[84] Problem analysis and solutions (1 – 4)
Problem Method of
analysis
Solutions
The color of one
area merges with
the color of
another area
'Quality check'
print
■ The media type defined on the
printer must be the same as the
media available on the printer. When
the media type defined on the printer
is not the same as the media
available on the printer, use the
'Change media type' wizard to
change the media type (see ‘Replace
the media’ on page 241)
■ Use coated media
■ Use the default drying time
■ Remove the printer from high
humidity conditions.
The color of one
line runs into the
color of another
line
'Quality check'
print
■ The media type defined on the
printer must be the same as the
media available on the printer. When
the media type defined on the printer
is not the same as the media
available on the printer, use the
'Change media type' wizard to
change the media type (see ‘Replace
the media’ on page 241)
■ Use coated media
■ Use the default drying time
■ Remove the printer from areas of
high humidity.