Oce TCS500 - Page 209

209
Optimize the output quality on the printer
White stripes in
filled areas
'Quality check'
print
■ Use the 'Presentation' quality
mode(see ‘Output type, output
quality and print speed’ on
page 188)
■ Use the 'Optimize print quality'
wizard to correct the problem (see
‘Use the Optimize print quality
wizard’ on page 212).
The output color is
not the same as the
original color
'Quality check'
print
■ Make sure you define the correct
software settings, for example the
correct pen settings.
■ Use the 'Presentation' quality mode
The length and
width
measurements are
different from the
original
'Quality check'
print
■ Make sure you defined the correct
scale settings
■ Use the 'Presentation' quality mode
■ Use the 'Optimize print quality'
wizard to correct the problem.
■ In case of a media length deviation,
adjust the setting Key Operator -
Printer - Media - Cut length
correction in the Océ Settings
Editor.
■ In case of a image length deviation,
set the Key Operator - Printer -
Vertical print optimization to 'Size
accuracy' and adjust Key Operator -
Printer - Image length correction
in the Océ Settings Editor.
The colored lines
are not well
aligned or blurred
'Quality check'
print
■ Use the 'Presentation' quality mode
■ Use the 'Optimize print quality'
wizard to correct the problem.
■ When failing printheads cause this
problem, use the 'Replace printhead'
wizard to replace the failing
printheads (see ‘Replace a defective
printhead’ on page 251).
[84] Problem analysis and solutions (2 – 4)
Problem Method of
analysis
Solutions