241
Replace the media
Maintain the Océ TCS500 printer
Replace the media
Introduction
The standard configuration of the Océ TCS500 contains two rolls of media . The Océ
TCS500 is also available with one roll or with three rolls. Appendix A contains a list
of the supported media types and media sizes.
This section describes the following.
■ How to remove and load a roll of media .
■ How to change the type of media defined on the system.
When to do
Change a roll when a job needs a media type or size that is not on one of the rolls.
Change the media type that is defined on the system when the defined media type
and the available media type do not correspond.
Before you begin
Use the Key Operator - System - Media - Paper series setting to define the correct
media sizes in the Océ Settings Editor.
How to remove a roll of media
1. Press the retract button on the right-hand side of the roll.
To Next Page
Loading...
