Oce TCS500 - Settings for Extended Scan-to-File Jobs

136 Chapter 5 Use the Océ TCS500 for scan-to-file jobs
Available settings for scan-to-file jobs
Settings for extended scan-to-file jobs
Available settings for scan-to-file jobs
The scan-to-file settings on the scanner operator panel
[50]
Setting Description
'Destination' Use this setting to define the default destination for
scan-to-file jobs on the controller. You can define a
maximum of 10 remote destinations and one of these
destinations is the default destination.
[101]
'File type' Depending on the color mode and file type you select
the values for the compression mode and organization
will change. For some File types, the Compression and
Organization settings cannot be set in all
situations.(see ‘'File type'’ on page 138)
'Resolution' Use this setting to define the resolution of the scanned
images. The higher the resolution you select, the finer
the image quality but the larger the file size.
(see ‘'Resolution'’ on page 139)
'Original type' Use this setting to define the type of original for your
scan-to-file jobs. The defined type influences the
quality of the output.(see ‘'Original type' and
background compensation’ on page 140)
'Original width' Use this setting to define the width of the original that
the scanner scans.(see ‘'Original width'’ on page 141)
'Remove strip' Use this setting to define blank areas on the sides of the
scanned image. (see ‘'Remove strip'’ on page 142)