Oce TCS500 - The Set Timer

55
The set timer
The set timer
Introduction
The set timer is only activated in case you want to copy a set.
When the scanner operator panel remains unused for a period of time after a set was
opened, the set closes automatically.
Use the set timer to define this period of time. The set timer is always enabled. You
can use the Océ Settings Editor to change the set time-out setting of the Océ TCS500
scanner.
The set time-out
The default value for the set time-out is 120 seconds.
If you must change the default value in the Océ Settings Editor proceed as follows.
[19]
[19] Change the Key Operator settings in the Océ Settings Editor
Step Action
1 Click 'File' and select 'Log on'.
2 Select 'Key Operator' and enter the password.
3 Click 'View' and select 'Key Operator settings'.
4 Navigate to the set time-out setting.
Key Operator - Scanner - Timers - Set time-out
5 Change the value.
6 Click 'Apply'.
7 Click 'File' and select 'Log off' to prevent unauthorized use.