Oce TCS500 - The Sleep Mode Timer

57
The sleep mode timer
The sleep mode timer
Introduction
If the Océ TCS500 scanner is not used for a longer period of time, the Océ TCS500
scanner enters the sleep mode automatically to save energy and the job settings are
set to default.
Use the sleep mode timer to define this period of time. The sleep mode timer is
always enabled. You can use the Océ Settings Editor to change the sleep mode
time-out setting of the Océ TCS500 scanner.
The sleep mode time-out
The default value for the sleep mode time-out is 15 minutes.
If you must change the default value in the Océ Settings Editor proceed as follows.
[21]
[21] Change the Key Operator settings in the Océ Settings Editor
Step Action
1 Click 'File' and select 'Log on'.
2 Select 'Key Operator' and enter the password.
3 Click 'View' and select 'Key Operator settings'.
4 Navigate to the sleep mode time-out setting.
Key Operator - Scanner - Timers - Sleep mode time-out
5 Change the value.
6 Click 'Apply'.
7 Click 'File' and select 'Log off' to prevent unauthorized use.