207
'Demo print'
'Demo print'
Introduction
You can make a demo print to get an impression of the print capabilities of the Océ
TCS500.
Use the 'Demo print' print option on the printer operator panel to trace output quality
problems. (see ‘Output quality problems’ on page 201)
How to make a demo print
The system prints the 'Demo print' in the 'Release' quality mode. The demo print
takes several minutes to print. You are recommended to use Océ Premium Grade
Paper (IJM113) for the 'Demo print'.
There are two methods to start the demo print.
■ Through the Océ System Control Panel
■ Through the 'System information' card on the on-line screen of the printer
operator panel.
To Next Page
Loading...
