Oce TCS500 - Set Océ TCS500 Printer Timers

58 Chapter 3 Prepare the Océ TCS500 for use
The energy save mode timer
Set the Océ TCS500 printer timers
The energy save mode timer
Introduction
The Océ TCS500 printer has 2 modes to prevent unnecessary power consumption.
■ The energy save mode.
■ The sleep mode.
This section describes the energy save mode.
The energy save mode
The Océ TCS500 printer uses less energy in the energy save mode than in the normal
operating mode.
Both the printer and the Océ Power Logic
®
controller remain turned on.
You can define the following energy save mode settings in the Océ Setting Editor.
[22]
Note: By default, the 'Energy save mode timer' is enabled and the 'Energy save
mode time-out' is set to 5 minutes.
If you must change the default settings in the Océ Settings Editor proceed as follows.
[22] Energy save mode settings in the Océ Setting Editor
Key Operator - Printer - Settings -
Timers - Energy save mode timer
enable - Energy save mode timer
Key Operator - Printer - Settings -
Timers - Energy save mode time-out
Enabled Use this setting to define the delay in
minutes before the Océ TCS500 printer
enters the energy save mode.
Disabled Not applicable