Oce TCS500 - Use Océ System Control Panel

88 Chapter 4 Use the PLC applications to control your workflow
Introduction to the Océ System Control Panel
Use the Océ System Control Panel to
control your workflow
Introduction to the Océ System Control Panel
Definition
The Océ System Control Panel application provides you with the following
information about the status of the system.
■ Status of the printer
■ Descriptions of the different types and sizes of available media on the system
■ Status of the scanner
■ Status of the controller
■ The amount of set memory in use.
You can access the Océ System Control Panel locally on the controller if you have a
keyboard, mouse and monitor with your Océ Power Logic
®
controller. If you do not
have a keyboard, mouse and monitor with your Océ Power Logic
®
controller you
must use Océ Remote Logic
®
to connect to the Océ System Control Panel.
See 'Océ Power Logic
®
controller: Océ Settings Editor' for information about how
to start the application locally on the controller.(see ‘Start the Océ Power Logic®
controller applications’ on page 73).
See 'Océ Power Logic
®
controller: Océ Remote Logic
®
' for information about how
to start the application from a remote workstation. (see ‘Start the applications with
Océ Remote Logic®’ on page 117).
User operations in the Océ System Control Panel
The Océ System Control Panel allows you to
■ Print your system configuration (see ‘Save, load and print the settings’ on
page 86)
■ Clear the system memory (see ‘Clear the set memory’ on page 271)
■ Shut down the system (see ‘Turn on and off the Océ TCS500 printer and the Océ
Power Logic® Controller’ on page 49)