Oce TCS500 - Perform a Basic Copy Job

163
Do a basic copy job
Do a basic copy job
Introduction
The main steps of a basic copy job consists of the following steps.
■ Feed the original.
■ Press the green start key.
How to copy on the Océ TCS500
1. Place the original face down and right aligned.
The scanner takes the original.
[129]
[129] Place the original face down and right aligned
2.
Press the green start key.
The scanner operator panel shows the copy job number and the status of the copy job.
Note: You can copy faster when you feed the original landscape.
Result
The Océ TCS500 makes a copy.