121
Log on to the controller applications
Log on to the controller applications
User modes
The Océ Power Logic
®
controller has the following user modes.
■ Key operator
■ Repro operator
■ System administrator
■ Service operator.
Chapter 1 contains more information about the types of users (see ‘The Océ TCS500
users’ on page 19). Chapter 5 contains more information about the user modes in the
Océ Settings Editor (see ‘Introduction to the Océ Settings Editor’ on page 74). Log
on to the correct user mode in the Océ Settings Editor to change the key operator
settings or the system administrator settings.
Only assigned operators are allowed to use the user modes. Different passwords are
required to access the user modes.
You do not need a password for the anonymous user mode.
Passwords
■ The default password for the system administrator is SysAdm.
■ The default password for the key operator is KeyOp.
■ The default password for the repro operator is ReproOp.
If a user is logged on, the user can change the password for the current user mode.
(see ‘Change the password’ on page 123)
Note: The passwords are case sensitive.
Authorization
Only one key operator, system administrator or repro operator at a time is authorized
to change the settings.
An error message appears when a second user tries to log on to the key operator
mode or system administrator mode.
There is no limitation of users authorized to view the settings.
To Next Page
Loading...
