Oce TCS500 - Change Job Attributes

149
Change job attributes
Change job attributes
Introduction
The Océ TCS500 printer allows you to change the job attributes of an active print
job.
How to change the job attributes of an active print job
1. Place the active print job on hold using the printer operator panel or using the Océ
Queue Manager How to place jobs on hold in the Océ Queue Manager.
2. Change the required attributes using the Océ Queue Manager (Media roll, Quality
mode, number of prints, color / Grayscale) (see ‘How to change attributes of jobs on
hold in the Océ Queue Manager’ on page 100).
3. Restart the print job using the printer operator panel or using the Océ Queue
Manager (see ‘How to restart jobs in the Océ Queue Manager’ on page 101).