Oce TCS500 - Use the Scanner Operator Panel for Scanning

129
Use the scanner operator panel
Use the scanner operator panel
Introduction
Use the scanner operator panel to define the job settings. You can define the job
settings in two ways.
■ Use the left softkeys and the scroll wheel.
You can use this method if you prefer a general step by step method.
■ Use the scroll wheel and scroll-wheel key only.
You can use this method if you prefer a fast method.
Know that the scanner operator panel also uses icons to explain a setting. The
following illustration shows the scanner operator panel of the Océ TCS500 scanner.
(see table 7).
Illustration
[97]
[97] The operator panel of the Océ TCS500 scanner
1
2
3
4
5
6
7
8
9
0