82 Chapter 4 Use the PLC applications to control your workflow
Define the job templates for your scanner operator panel
Define the job templates for your scanner operator panel
Introduction
Job templates enable you to easily perform copy jobs and scan-to-file jobs that you
do very often. Job templates display on the scanner operator panel when you select
'Copy' or 'Scan-to-file'.
A job template defines the following.
■ The top 5 settings.
You can select 5 settings that you want to see immediately when you open the job
template at the scanner operator panel. The top 5 settings are the settings that you
need to change frequently if you use this job template. You can see the remaining
settings when you scroll downwards.
■ The default values for all available settings.
You can define a default value per setting. Define a value that you use very often.
Before you begin
Open the Océ Settings Editor and log on as Key Operator. Take the following steps
to log on.
1. Click 'File' and select 'Log on'.
2. Select 'Key operator' and enter the password.
How to define a job template
1. Click 'View' and select 'KO settings'.
2. Navigate to Key Operator - Jobs - Copy - Copy job templates to define the copy
job templates.
Navigate to Key Operator - Jobs - Scan to file - Scan to file job templates to define
the scan-to-file job templates.
3. Define the job template name and the job template description.
4. Select the top 5 settings that you want to see on the scanner operator panel when you
open the job template.
5. Define the number of prints / sets.
6. Select a default value for all the settings that you want to pre-define for your job
template.
7. Click 'Apply' to confirm the settings.
8. Click 'File' and select 'Log off' to prevent unauthorized use.
To Next Page
Loading...
