Oce TCS500 - Configure Network Settings

66 Chapter 3 Prepare the Océ TCS500 for use
Configure the network settings of the Océ TCS500
Configure the network settings of the Océ TCS500
Introduction
The system administrator is responsible for installing and configuring the Océ
TCS500 in the network environment. There are two ways to configure the network
settings.
■ From the printer operator panel
The off-line screen on the printer operator panel contains a wizard to configure
the network settings.
■ With the System Administrator settings in the Océ Settings Editor.
The Océ Settings Editor allows you to configure a large number of system
settings. Only the system administrator is authorized to define the system
settings.
Actions in the Configure system wizard
You can perform the following actions in the 'Configure system' wizard.
■ Enable DHCP
■ Set the IP address
■ Set the IP subnet mask
■ Set the default gateway
■ Configure the DNS settings
■ Configure the primary and secondary WINS
■ Clear the set memory. (see ‘Clear the set memory’ on page 271).
Use this option for a damaged job that you cannot delete in the Océ Queue
Manager.
The 'Configure system' wizard also contains installation settings and service
settings. A password protects the installation settings and the service settings. Only
Océ service engineers can access the installation settings and the service settings.
How to configure the system from the printer operator panel
1. Press the on-line / off-line key to set the printer off-line (see ‘The on-line mode and
the off-line mode’ on page 36).
2. Use the upper softkeys to scroll to the 'Configure system' card.