Oce TCS500 - Page 183

183
Make a copy of a specific area of an original
How to copy a specific area of an original
1. Place the original face down and right aligned.
The scanner takes the original.
2. Define the job settings.
■ Select 'Copy' with the upper-left softkey.
The copy job templates appear.
■ Open a copy job template with a left softkey.
The top 5 settings display.
■ Scroll to 'Remove strip' and open this setting with the left softkey.
■ Define the 'Leading' strip value with the scroll wheel or numeric keys.
■ Select 'Trailing' with the left softkey and define the value with the scroll wheel or
numeric keys.
■ Select 'Left' with the left softkey and define the value with the scroll wheel or
numeric keys. 'Left' is the left side of an original that is turned face up.
■ Select 'Right' with the left softkey and define the value with the scroll wheel or
numeric keys and close the setting. 'Right' is the right side of an original that is
turned face up.
■ Scroll to 'Alignment' and open this setting with the left softkey.
■ Define the value of the 'Horizontal' setting to 'Center' with the scroll wheel.
■ Select 'Vertical' with the left softkey and define 'Center' with the scroll wheel.
[67]
3. Define the number of copies if necessary and press the green start key.
Note: To measure the size of a strip you can use the ruler available at the scanner
(metric).
Result
The Océ TCS500 copies a specific area of the original to the specified position on
the copy.
[155] [156] [157] [158]
The 'Leading' strip The 'Trailing' strip The 'Left' strip The 'Right' strip