Oce TCS500 - Page 257

257
Replace the maintenance cassette
How to remove the maintenance cassette
1. Press the on-line / off-line key on the printer operator panel to set the printer off-line.
If you replace the cassette as the result of the message 'Maintenance cassette full.
Press Continue to start the Replace cassette wizard.', press the softkey for 'Continue'
to enter the 'Replace cassette.' wizard. Then continue with step 4.
[202]
2. Use the upper softkeys to scroll to the 'Replace cassette' card.
[203]
3. Press the softkey below the 'Replace cassette' card to enter the wizard.
An introduction screen displays the message 'Use this wizard to replace the
maintenance cassette.'
[204]
4. Use the upper right softkey to enter the wizard at the introduction screen.
The screen displays the message 'Carriage moving to center position...' while the
carriage moves to the center.
Then, the screen displays the message 'Open maintenance door.'
5. Open the door to the maintenance cassette.
The screen displays the message 'Remove cassette.'
6. Press the green grip to the left to release the cover that gives access to the
maintenance cassette.