Changing settings from the operator panel
- 113 -
Item
Factory
default
Description
NetBIOS over TCP Enable Enables/Disables the NetBIOS over TCP
Web Enable Enables the access from the web browser.
Displayed when the TCP/IP protocol is
Telnet Disable Enables the access using Telnet.
Displayed when the TCP/IP protocol is
FTP Disable Enables the access via FTP.
Displayed when the TCP/IP protocol is
IPSec Disable Displayed only when IPSec is enabled. It
can be changed to Disable only.
Displayed when the TCP/IP protocol is
SNMP Enable Enables the access from SNMP.
Displayed when the TCP/IP protocol is
Normally, [Small] is selected.
Network Factory Defaults Execute Restores network menu settings to factory
Wired(LAN1)
Setup
Enables/Disables the wired LAN1.
IP Address Set Auto Set to obtain the IPv4 address automatically
IPv4 Address xxx.xxx.xxx.x
Input the IPv4 address manually. Displayed
when [IP Address Set] is set to [Manual].
Subnet Mask xxx.xxx.xxx.x
Input the subnet mask. Displayed when [IP
Address Set] is set to [Manual].
Gateway Address xxx.xxx.xxx.x
Input the gateway address. Displayed when
[IP Address Set] is set to [Manual].
DHCPv6 Disable Set to obtain the IPv6 address
automatically. Set to [Disable] when you do
not use the IPv6 address.
HUB Link Setting Auto
Sets the connection method to the hub.
System
Adjust
Power Save Time 1minute Sets the time that will elapse before the
power save mode is entered.
Value range: 1 minute, 2 minutes, 3
minutes, 4 minutes, 5 minutes, 10 minutes,
15 minutes, 30 minutes, 60 minutes
Sleep Time 15minute Sets the time that will elapse before the
sleep mode is switched from the power save
mode.
Value range: 1 minute, 2 minutes, 3
minutes, 4 minutes, 5 minutes, 10 minutes,
15 minutes, 30 minutes, 60 minutes
Auto Power Off Time 4hours Sets the time that will elapse before the
power is turned off automatically after the
standby mode is entered.
Value range: 1 hour, 2 hours, 3 hours, 4
hours, 8 hours, 12 hours, 18 hours, 24
To Next Page
Loading...
