Changing settings from the operator panel
- 112 -
Item
Factory
default
Description
Quiet Mode Off Sets the quiet print mode to reduce the
noise during printing. The print speed
becomes lower when [On] is set.
Ultra Light Paper Care Mode Off If the following phenomena occur when you
are printing with [Media Weight] set to [Ultra
Light] or [Light], setting it to [On] may
improve the situation. But, the printing
speed becomes lower.
Thin stripes appear along the paper
travel direction.
An after-image is printed on either the
top, bottom, left or right side of light-
colored texts or images, about 94 mm
*1 Factory default setting values are different according to the country or region.
*2 The values are displayed with the unit set in [Admin Setup] - [Tray Setup] - [Unit of Measurement].
Easy Setup
Item
Factory
default
settings
Description
Enter Password ********** Input the password required to enter the
Language
Select Language English Selects the display language of the display.
Time Setup
Sets the date in the format of yyyy/mm/dd.
Time Zone +9:00 Sets the GMT time zone.
Value range: -12:00 to +13:00 (in
increments of 15 minutes)
Daylight Saving Off Sets the daylight saving (daylight saving
Setting method Manual
Selects how to set the time.
Sets the SNTP server used to set the
current date and time. Up to 64 characters
can be used.
Displayed when [Auto Config] is selected as
SNTP Server (Secondary) (Blank)
Time Setting 2001/01/01
00:00:00
The time is set at factory delivery. Change
the date and time if necessary.
Displayed when [Manual Setup] is selected
Admin
Password
Input a new admin password.
Verify Password Input the new admin password again to
Network
Setup
General
Setup
Extended Network Disable
Selected when you want to enable any other
network than the standard wired LAN.
Enabling Default Gateway Wired(LAN1)
Specifies the network connection method for
segment-based communication.
Enables/Disables the wired LAN.
To Next Page
Loading...
