Changing settings from the operator panel
- 111 -
Item
Factory
default
Description
High Humid Mode Off The paper may curl when the paper is
ejected at a high humidity. Set this setting to
[Mode1] or [Mode2] to reduce the curling
effect.
Try [Mode2] if [Mode1] does not reduce the
paper curling effect.
The printing time is longer than the case of
[Off].
When [Mode1] or [Mode2] is set, the service
life of the image drum will be shortened.
Office Document Mode Mode1 In the case of Mode 1, toner is saved
according to the setting of [Admin Setup] -
[Print Setup] - [Toner Save] - [Toner Save
Level].
In the case of Mode 2, if [Toner Save Level]
is set to [Off], toner is saved by 5%. When
[Toner Save Level] is set to [Low], [Middle]
or [High], toner is saved according to the
Moisture Control Off Enables/Disables the moisture control.
When [Mode1] or [Mode2] is set, it is
possible to prevent the paper from
absorbing moisture at high humidity and
prevent the paper from getting wet. It may
take much time to print the first page.
Narrow Paper Speed Mode1 Sets the printing speed when narrow paper
is used.
The target paper weight ranges from Ultra
Light to Medium.
Mode1:
The recommend mode for massive printing
on narrow paper (with a width of 216 mm or
less).
Switches the speed to a low speed when
printing on narrow paper.
Mode2:
The recommend mode for printing on a
small amount of narrow paper. Prints on
narrow paper without reducing the speed.
When printing on a large amount of narrow
paper, it is easier to begin the waiting time
for fixing temperature adjustment.
Mode3:
To print on wide paper after printing a large
amount of narrow paper, poor printing may
occur at the edge of paper. In this case, this
mode is recommended to reduce the poor
printing.
To start printing on wide paper after printing
on narrow paper, the waiting time for fixing
temperature adjustment may be available.
Switches the speed to a low speed when
printing on narrow paper.
To Next Page
Loading...
