Oki C650 - Page 117

Changing settings from the operator panel
- 117 -
Item
Factory
default
settings
Description
IPv4 Address 192.168.101.
100
Input the IPv4 address manually.
Displayed when [IP Address Set] is set to
[Manual].
Subnet Mask 255.255.255.
0
Input the subnet mask.
Displayed when [IP Address Set] is set to
[Manual].
Gateway Address 0.0.0.0 Input the gateway address.
Displayed when [IP Address Set] is set to
[Manual].
DHCPv6 Disable Set to obtain the IPv6 address
automatically. Set to Disable when you do
not use the IPv6 address.
Auto Setup
(WPS)
WPS-PBC Executed when setting is done by pressing
the WPS button of the wireless LAN access
point.
WPS-PIN Executed when the PIN code displayed on
this machine is registered with the wireless
LAN access point.
Wireless
Network
Selection
xxxxxx
......
Displays a list of wireless LAN access point
names found by the search.
Manual
Setup
SSID
Input the SSID.
Security Disable Sets the security of the wireless LAN
function.
WEP Key
Input the WEP key.
WPA
Encryption
Type
Displays the WPA-
PSK encryption type. The
setting is carried out automatically according
to the security settings. (Impossible to
switch in this menu)
WPA Pre-
shared Key
Input the pre-shared key. Displayed when
[Security] is set to any other value than
[Disable] or [WEP].
Execute
Executes the changes to security settings.
Wireless Reconnection Reconnects to the wireless LAN
(infrastructure).
*1 Factory default setting values are different according to the country or region.
*2 The values are displayed with the unit set in [Admin Setup] - [Tray Setup] - [Unit of Measurement].
Admin Setup
Item
Factory
default
settings
Description
Enter Password ********** Input the password required to enter the
Admin Setup menu.
Network
Setup
General
Setup
Extended Network Disable
Selected when you want to enable any other
network than the standard wired LAN.
Enabling Default Gateway Wired(LAN1) Specify the network connection method for
segment-based communication.
TCP/IP
Enable
Enables/Disables the wired LAN.
NetBIOS over TCP Enable Enables/Disables the NetBIOS over TCP
protocol.