Changing settings from the operator panel
- 119 -
Item
Factory
default
Description
Copies 1 Sets the number of copies.
The value set in the printer driver takes
Duplex On Sets whether or not to implement duplex
printing.
The value set in the printer driver takes
Binding Long Edge Specifies the binding method for duplex
printing.
The value set in the printer driver takes
Media Check Enable Sets whether to check the mismatch
between the paper size of the print data and
A4/Letter Override Yes Sets the functions of auto switching the
printing paper from A4 to Letter when A4
paper runs out and Letter paper is loaded,
or from Letter to A4 when Letter paper runs
Resolution 600 dpi Sets the resolution.
The value set in the printer driver takes
Toner Save
Sets the toner save level.
Color All Specifies whether to apply toner save to
Mono-Print Mode Auto Sets the print mode of mono pages.
[Auto] controls the print mode with a good
balance.
[Color Mode] is suitable for printing a large
amount of color pages.
[Normal Mode] is suitable for printing a large
amount of mono pages.
Changing mono print mode(P.170)
Color Ready Mode Off Sets whether or not to prepare for the next
color printing after the printing has
Default Orientation Portrait Specifies the print orientation. For
PostScript, this setting is disabled.
Edit Size Cassette
Size
Sets the size of the drawing area when the
size is not specified by the paper size edit
Trapping Off Set when white streaks appear between
X Dimension 210
Sets the default value of paper width for
Y Dimension 297
Sets the default value of paper length for
PS Setup L1 Tray Type1 Sets the tray selection number of PostScript
level-1 operator commands.
Network Protocol RAW Specifies the PS communication protocol for
USB Protocol RAW Specifies the PS communication protocol for