Troubleshooting
- 332 -
Caution: Non-Genuine
consumable detected. Check
user's Manual "Trouble Shooting"
to restore machine operation
709 You can use any consumables/maintenance parts, but the print
quality may be lowered and the optimum performance may not
be obtained.
If the use of non-genuine consumables/maintenance parts
causes damage to the product or results in your product not
functioning to its full specification, such damage or effects on
the product are not covered by warranty.
When you understand the above points and use non-genuine
consumables/maintenance parts, follow the procedure below.
Power off the main unit.
Power on the main unit. When the OKI logo appears on
the display, press «CANCEL» on the operator panel.
When [Ready To Print] appears, release «CANCEL».
The above operation will be recorded inside this machine.
Error While Initializing Settings
Press OK To Hide This Message
751 The initial value set with the NFC Setting Tool is not properly
reflected in the device settings. Please check a setting value.
Power Off and Wait for a while.
126:Condensing Error
Fatal 126 Condensation has occurred inside this machine.
Turn off the power, and then turn the power back on after a
while.
If the same error message is displayed, contact your dealer.
Recovered from the error nnn
Print again if the printing result
does not come as expected
Press OK To Hide This Message
- An error has occurred inside this machine, and the machine
has restarted. Check that the print result comes as expected,
since the machine may restart during printing.
Print again if the printing result does not come as expected.
Service Call
- An error has occurred inside this machine.
Please contact your dealer.
Communication Error - An error has occurred in this machine. Restart this machine.
If the error persists, contact your dealer.
Detected An Abnormality Of
Internal Database
The Data Must Be Deleted
After Pressing [OK], The Data Will
Be Deleted, And Then Reboot
- An error has occurred in the internal database of this machine.
Press «OK» on the operator panel to delete the database and
restart this machine.
Language Change Failed. Error
- Failed to change the display language on the display.
Restart this machine, and reset the language setting.
Firmware Update Error. Perform
Firmware Update Again
If The Same Error Message
Appears, Please Contact Our
- Firmware update has failed.
Please update the firmware again. For details, see "Firmware
update(P.324)".
PU Flash Error - An error has occurred in this machine.
Please contact your dealer.
Memory Is Not Enough. Please
Reduce Resolution Or Finish The
Function
Press OK To Hide This Message
- The memory is insufficient.
Print again after lowering the printing quality in the printer
driver.
Manual Printing. Set Media Size In
MPTray
Press OK To Start Printing
- The print mode has been specified in which paper is loaded in
the MP tray and fed one by one.
Load proper paper in the MP tray, and press «OK» on the
operator panel.
If you are printing a multi-page document, the same massage
appears each time after one page is printed. Press «OK» each
To Next Page
Loading...
