Oki MC573 - Searching for a Destination in the LDAP Server

- 179 -
5. Fax
You can search for a destination from a list on the LDAP server. There are two search
methods, as shown below.
• [Simple Search]: You can run a search with only one keyword as a user
name. You can only search for character strings included in usernames, and
not in e-mail addresses.
• [Advanced Search]: You select search conditions to search for items that
include all the specified keywords or any of the keywords. You can specify
user names or e-mail addresses as search keywords.
Up to 100 search results are displayed.
For details on setting the LDAP server, refer to "Setting the LDAP Server".
1
Press [Fax/Internet Fax] or (Fax).
2
Set a document in the ADF or on the document glass.
3
Press [Internet Fax].
4
Check that [To] is selected.
To select [Cc] or [Bcc], press [To] several times.
5
Press [LDAP] on the [Internet Fax] or [Basic] tab.
6
Press [Simple Search] or [Advanced Search].
7
Enter a keyword to search.
Entering Characters (User's Manual)
8
Press [OK].
9
When the search results are displayed, press the destination.
10
When you complete the selection of all the destinations, press [OK].
11
Press [Back] to return to the start screen.
12
Set scan settings if necessary.
13
Press the (START) button.
Specifying a destination in other methods
Entering a Destination E-mail Address
Specifying a Destination from Address Book/Group List
Selecting a Destination Using One Touch Buttons
Selecting a Destination from Transmission History
Searching for a Destination in the LDAP Server