Oki MC573 - Setting TAD Mode

- 218 -
5. Fax
Set an operation type in Ans/Fax Ready mode.
1
Press [Device Settings] on the touch panel.
2
Press or several times and press [Admin Setup].
3
Enter the administrator name and password and press [OK].
The factory default administrator name and password are "admin" and "999999"
respectively.
4
Press [Fax Setup].
5
Press [Fax Setting].
6
Press or several times and press [TAD Mode].
7
Select a type.
• [Type 1]: Fax signal detection starts immediately after the answering machine/
telephone responds. If the sender is sending a fax, the fax reception starts
automatically.
When the answering machine finishes responding, the fax reception starts.
If there is a problem with a fax reception, using this type may improve the problem.
• [Type 2]: Fax signal detection starts immediately after the answering machine/
telephone responds. If the sender is sending a fax, the reception starts automatically.
Even after the answering machine finishes responding, the fax reception does not
start.
If you usually receive calls, use this type.
• [Type 3]: Fax signal detection starts in 15 seconds after the answering machine/
telephone responds. If the sender is sending a fax, the reception starts automatically.
When the answering machine finishes responding, the fax reception starts.
Use this type for normal use.
8
Press [Back] until the home screen is displayed.
Setting TAD Mode