- 344 -
9. Operating Management/ Specifications
*1 A message is displayed to confirm the equipment restarts. Select [Yes] to continue. Select [No] to cancel.
*2 When you set the dial tone detection setting to [ON], the machine does not dial if the dial tone is not detected.
Business Phone Setup
DRD Type Type 1 Set Distinctive Ring Detection.
Type 1
Type 2
Type 3
Type 4
Dial Tone Detection*
2
OFF Sets whether to detect a dial tone.
Busy Tone Detection ON Sets whether to detect a busy tone.
Monitor Control OFF Select from three choices.
OFF: Not to monitor.
Type 1: To monitor for about five seconds after
being connected to the sender when receiving
faxes or from the time you are connected to
the receiver to the time the fax signal is
received when sending faxes.
Type 2: To monitor all the time.
Monitor Volume Middle Sets the Monitor Volume.
OFF
Low
Middle
High
TTI Register /
Edit
TTI 1 (NULL) Registers or changes the transmission
terminal identification (the name of a sender).
You can enter up to 22 characters.
TTI 2
TTI 3
Standard TTI TTI 1 Selects the default sender's name from the
registered list.
TTI 1
TTI 2
TTI 3
TTI Number (NULL) Register the fax number of this machine.
TTI Calendar Type dd/mm/yyyy or
mm/dd/yyyy
Sets the calendar date format of sender's
information.
Super G3 ON Sets whether to use Super G3 (ultra high-
speed communication mode).
Wireless Module Disable Sets whether to enable or disable wireless
LAN.
Erase Privacy Data*
1
- Deletes the registered privacy data.
• Data saved to E-mail address list,
phonebook, profile, one-touch buttons
• Values set to the Admin Password and other
menu items.
• Fax communication data
• Various histories
• Access control information and user
information registered to the device
Item Factory
default
setting
Description
Item Factory default setting Description
Business Phone Cooperation Disable Sets whether to enable Business
Phone Cooperation.
Connection IP Address 0.0.0.0 Sets the IP address of the connected
device.
Connection Port No. 59000 Sets a port number of the connected
device.
To Next Page
Loading...
Need help?
General
