- 63 -
2. Copy
• If all the values are set to [0], [Margin] is disabled.
• You can set [Margin] as default so that you do not have to set margins every time you make copies.
• The value of the margin can be changed from [Device Settings] > [Admin Setup] > [Copy Setup] > [Default Settings]
> [Margin] on the touch panel.
Copying with Margins on One Side
Set margins to a simplex document before copying.
Set [Direction] correctly.
Changing the Document Orientation (Direction)
1
Press [Copy] or the (COPY) button.
2
Set a document in the ADF or on the document glass.
3
Press [Margin] on the [Advanced] tab.
4
To set the left or right margin, specify a margin in [Left] of [Front] by using the
numeric keypad or by pressing , , and [+/-].
•
To create a margin on the left side of the output, specify a positive value.
•
To create a margin on the right side of the output, specify a negative value.
5
To set the top or bottom margin, specify a margin in [Top] of [Front] by using
the numeric keypad or by pressing , , and [+/-], and then press [OK].
•
To create a margin at the top of the output, specify a positive value.
•
To create a margin at the bottom of the output, specify a negative value.
To Next Page
Loading...
