- 91 -
3. Scan
• Simple Scan mode: You can start scanning anytime if the machine is in
standby status.
• Manual Scan mode: Turn on the Remote Scan function on the touch panel
before starting scanning.
• Secure Scan mode: You can just operate from a computer specified when
you turn on the remote scan function on the touch panel. Only one computer
can be connected at a time.
If you perform a remote scan via the WSD Scan connection, you can scan from computers
that are already registered in this machine, regardless of the Remote Scan modes.
1
Press [Device Settings] on the touch panel.
2
Press or several times to select [Admin Setup].
3
Enter the administrator name and password and press [OK].
The factory default administrator name and password are "admin" and "999999"
respectively.
4
Press [Scanner Setup].
5
Press or several times to select [PC Scan Mode].
6
Select a scan mode, and then press [OK].
7
Press [Back] until the home screen is displayed.
If [Manual Scan Mode] or [Secure Scan Mode] is selected, remote scan buttons
appears on the home screen.
To Next Page
Loading...
