Panasonic VF100 - P097: Analog and PWM Output Function Select

P097：Analog and PWM output function select
Used to set function of "0~10V voltage signal" output with control circuit terminal No.17 and "output
state signal (PWM)" output with terminals No.10-12.
[Relationship between 0~10V voltage signal and output frequency and output current]
0
Output frequency
Voltage
signal
output
Duty
factor
Duty
factor
Voltage
signal
output
10
Max. output
frequency
（V）
0
10
150% of rated
output current
Output current
＜In proportion to output frequency ＞ ＜n proportion to output current＞
[Relationship between output signal and output frequency and output current]
（%）
0
Output frequency
75
＜In proportion to output frequency＞ ＜In proportion to output current＞
0
75
Output current
・ For the purpose of acquiring "PWM output" with terminals No.10-12, parameter P090 (output
TR1 function select) is required to be set to "11".
（V）
（%）
[Precautions on 0~10V voltage output and output state signal (PWM)]
・ The indications of the output signal are not the accurate indications for measuring. Use those
indications to get rough values.
(If you need the accurate values, use a separate measuring instrument.)
・ Note that the signal in proportion to output current may output large signal value under 40%
of rated current.
(For example, signal level will be output to a certain extent even if no output current is available.
But if the inverter is in the stopping state, "0 level" is output.
Max. output
frequency
150% of rated
output current
・ Cycle of PWM output signal is "1ms".
Output signals in proportion to output current 1
Output signals in proportion to output frequency0
Details
Data setting
value
Note
109
P090, P098
Related
parameters