Panasonic VF100 - Initial Settings for Custom Parameter No.1-10

Note
・ After the distribution is completed, the inverter will not run unless the MODE button is pressed
and the "operation status display mode" is set to.
・ During data changing, the "0V stop state" will be returned to if the inverter 0V stops.
・ While changing the data, the mode will return to the "operation status display mode" if a stop
signal is input and the inverter stops.
・ While changing the data in the "0V stop state", the mode will return to the "operation status
display mode" if the inverter enters operation state.
0000
0
0
50.0
50.0
0
0
05
5.0
5.0 62
62
68
63
64
69
69
136
138
139
Initial
value
Password
P150U010
Alarm LED operation select P147U009
Operation status monitor
P145U008
Base frequency
P009U007
Max. output frequency
P008U006
Frequency setting signal
P004U005
Operation command select
P003U004
Torque boost level
P007U003
1
st
deceleration timeP002U002
1
st
acceleration timeP001U001
Related
page
Function name
Function
parameter No.
Custom
parameter No.
Initial settings for custom parameter No.1~10 are shown in the table as below.
For making the distribution setting of custom parameter No.1~10 return to initial state, value of
function parameter "P151: Setting data clear" is set to "3". (The data value is not changed.)
(Refer to page 140.)
・ The distribution of custom parameters is stored in the panel, so such distribution is still valid even
if the panel is removed from this inverter and then installed on other inverters.
142