DT001
DT323
・
・
・
・
・
・
DT123
R310
BIT F
BIT E
BIT D
BIT C
BIT 3
BIT 2
BIT 1
BIT 0
BIT F
BIT E
BIT D
BIT C
BIT 3
BIT 2
BIT 1
BIT 0
・・
・
・・・
Data address
Contact address
（Input register）
（Holding register）
Coil（Discrete output ）
（Discrete Input）
4) There is no distinction between Coil (Discrete output) and Discrete input.
If the address is the same, it indicates the same contact No..
5) There is no distinction between Input register and Holding register.
If the address is the same, it indicates the same contact No..
6)
Setting value of parameter P142 changes depending on communication speed.
171
In MOD-BUS (RTU) communication, the start and end of the frame is normally set to 3.5
byte time with "P142: TEXT completion judgment time" in the inverter.
To Next Page
Loading...
