LIFEPAK 15 Monitor/Defibrillator
Service Manual
Modes of Operation
Manual Mode
Section Menu Section Contents Back Index
90
4
Manual Mode
Entering Manual Mode
To enter Manual mode, turn on the device. The factory default settings allow direct access to Manual mode. This access can be
modified to require confirmation or a passcode, or can be restricted entirely.
To change Manual mode access:
1. Select MANUAL MODE in the Setup menu (see Setup Mode (p. 92)).
2. In the Setup/Manual Mode submenu, select MANUAL ACCESS.
Table 4.1— Mode Response Descriptions
Mode/Response When Turned On Response Description
Manual/Direct (default) Turn on in Manual; direct access between AED and Manual modes
AED/Direct Turn on in AED; direct access between AED and Manual modes
AED/Confirm Once Turn on in AED; operator confirms Manual mode selection once
AED/Confirm Always Turn on in AED; operator confirms Manual mode selection every time
AED/Passcode Once Turn on in AED; operator enters Manual mode passcode once
AED/Passcode Always Turn on in AED; operator enters Manual mode passcode every time
AED/Restricted Turn on in AED; no access to Manual mode
To Next Page
Loading...
