Pilz PMCprotego D.48 - 7.4.4 Advanced menu; 7.5 Messages;errors; 7.5.1 Status messages

Commissioning
Operating Manual PMCprotego D.48, PMCprotego D.72
1001735-EN-04
195
7.4.4 Advanced menu
In the advanced menu you can also change numerical values.
} Keep the right-hand button pressed down as you switch on the 24V supply voltage
Status
or
or
or or
or
or
or
or
or
or
9-digit serial number: 3 blocks,
Decimal point shows number of block
Block 1 Block 2 Block 3
Command M_RESET (macros are recompiled)
Command RSTVAR (parameters are set to default values)
Save data in EEPROM
Load data from EEPROM
MDRV (Multilink)
Brake
MDRV (Multilink)
Motor type see reference list in motor database
Setpoint value offset [mV]
Tn speed controller [mV]
KP speed controller
Transmission rate
Station address
Fig.: Advanced menu
7.5 Messages/errors
7.5.1 Status messages
Status messages on the LED display indicate the operating status of the servo amplifier.
No. Error message Description
E/S/A/P Status messages Status message, no error
. . . Status message Amplifier updating the start configuration
- Status message Status message, no error, programming mode
- S - STO-ENABLE STO-ENABLE input = 0V (if the drive is shut down)
CCC SD card Problem when accessing the SD card