Pilz PMCprotego D.48 - 5.5.3 Expansion cards for slot 3

Installation
Operating Manual PMCprotego D.48, PMCprotego D.72
1001735-EN-04
96
5.5.3 Expansion cards for slot 3
The following expansion cards are available for slot 3:
} PMC expansion card PosI/O,
} PMC expansion card PosI/O-AIO
} PMCprotego S1-2
} PMCprotego S2-2
} Fan controller, controlled fan (cannot be retrofitted)
The procedure for incorporating the expan-
sion card into slot 3 is similar to that de-
scribed for slot 1.
Remove the front membrane.
Lever out the cover plate beneath the film.
Insert the expansion card into the slot.
Using suitable pliers, pull out the blank in
the slot (STO bridge).
Please note: You should retain the blank. It
must be inserted if no expansion card is
plugged into slot 3. If not, it will not be pos-
sible to enable the servo amplifier.
Insert the expansion card into the slot.
Fasten the front plate of the expansion card
using the screws provided.