Pilz PMCprotego D.48 - 6.7.5 Encoder systems; 6.7.5.1 HIPERFACE DSL, one-cable connection

Wiring
Operating Manual PMCprotego D.48, PMCprotego D.72
1001735-EN-04
126
Input circuit Analogue input
+O1
9
ANALOG-IN1-
10
11
12
AGND
13
PMCprotego
-O1
+/- 10 V
+O2
-O2
+/- 10 V
CNC-GND
GND
X3B
Shield
ANALOG-IN1+
ANALOG-IN2-
ANALOG-IN2+
- Signal range –10 ... +10 V
- Referenced to earth: Al-
ways connect AGND
(X3B/13) to CNC-GND on
the control system
- Twisted pair, shielded
- Shield connection on the
front plate
Connection
6.7.5 Encoder systems
6.7.5.1 HIPERFACE DSL, one-cable connection
Under “Connection cables”, please note the requirements for the:
} Cable cross sections
} Insulation material
NOTICE
The connection cable must not exceed the maximum length of 25 m.
The connection cable must not be interrupted or separated.