Planmeca Compact I User Manual

Chapter D - HELP & ERROR MESSAGES
D-8 Planmeca Compact i
ERROR MESSAGES
Technical Manual
E27
reserved
INSTRUMENT MULTIPLEXER RELATED
E28.n
Error in instrument hose identification system in IMUX. page D-14
E29
Voltage error in fibre light power supply in IMUX. page D-14
E30
reserved
E31
reserved
E32.n
Error in serial communication between MCB and IMUX. page D-14
E33.n
IMUX output short circuit (valve or wire short circuit). page D-15
E34.n
IMUX output open-circuit (valve or wire open-circuit). page D-15
E35.n
IMUX pressure sensor offset error (signal outside range). page D-15
E36.n
IMUX pressure sensor error (signal voltage too high). page D-16
E37
Pressure sensor cable not properly attached to the IMUX. page D-16
E38
reserved
E39
Drive (cooling) air valve control servo cannot maintain pressure to instrument. page D-16
E40
reserved
E41
reserved
E42
Air coolant (spray air) valve control servo cannot maintain pressure to instru-
ment.
page D-16
E43
reserved
E44
reserved
E45
Water coolant (spray water) valve control servo cannot maintain pressure to
instrument.
page D-17
E46
reserved
SUCTION TUBE HOLDER RELATED
E47.n
Suction tube holder is of new type. Update the MCB software. page D-17
E48.n
Number of attached suction tube holders is wrong. page D-17
E49.n
Suction tube holder cable or electronics is faulty. page D-17
E50
reserved
FOOT CONTROL RELATED
E51.n
Cable from the foot control is loose page D-18
E52
Foot control is of a new type. Update software on MCB. page D-18
E53
Foot control serial communication (data) failure. page D-18
E54.n
Foot control is not properly calibrated. page D-18
E55
reserved
Error Explanation Details on:

Planmeca Compact I Specifications

General

Spittoon	Yes
Operating Light	LED
Imaging Technology	Digital
X-ray Tube Voltage	60-70 kV
X-ray Tube Current	7 mA
Focal Spot Size	0.8 mm
Exposure Time Range	3.2 s
Power Supply	50/60 Hz