Polycom 1500 - Page 152

Polycom RealPresence Collaboration Server (RMX)1500/2000/4000 Deployment Guide for Maximum Security Environments
5-14 Polycom, Inc.
If HTTPS is enabled, a Security Alert screen is displays.
b Click Yes to proceed and display the Administrator login screen. Click No to cancel
the current operation.
c Type a user name and password.
d Click Login.
2 Enable Maximum Security Mode:
a In the Gateway interface, on the sidebar, click Device.
b Click the Security tab.
c In the Security mode field, select Maximum (no Telnet, ftp, SNMP and ICMP)
3 Verify the Advanced Settings for Maximum Security Mode:
a In the Gateway interface, on the sidebar, click Gateway.
a Click the Settings tab.
a Click Advanced >> Commands.
The Advanced Settings dialog box is displayed.
b Enter the Advanced Commands in Table 5-2 and observe the returned Status Messages.
If necessary, modify the settings to match those listed in the table.
For more information see "Advanced Commands” on page 5-16.
Table 5-2 Maximum Security - Advanced Command Settings
Advanced Command Status message
Status
After
Setting/
Enable
advancedsecuritymode Advanced Security Mode is currently DISABLED Advanced
Security
mode -
ENABLED
embeddedMode ENABLED
daysForPassword
ExpireNotification
Number of days till password expiration is set to 7 NO
CHANGE
NEEDED
h239OlcPatch ENABLED
IsdnCapsTimeout 15
lowerCaseMinimum Minimum lower case chars in password is set to 2 NO
CHANGE
NEEDED
MinNumberOfChangedChars Minimum number of changed chars in password
is set to 4
NO
CHANGE
NEEDED