Polycom 1500 - Realpresence Collaboration Server (RMX) Hardware; Installation and Configuration

Chapter 1-First Time Installation and Configuration
Polycom, Inc. 1-3
information see the RealPresence Collaboration Server (RMX) 1500/2000/4000
Administrator’s Guide "Certificate Configuration and Management” on page F-1.
RealPresence® Collaboration Server (RMX) Hardware
It is required that MPM+ or MPMx cards are installed in the RMX.
Installation and Configuration
First Time Installation and Configuration of the RMX 1500/2000/4000 consists of the
following procedures:
1 Hardware Installation and Setup
— Mount the RMX in a rack.
— Connect the necessary cables.
2 Gather Network Equipment and Address Information
— Get the information needed for integrating the RMX into the local (Signaling and
Management) networks.
3 First Entry Configuration
— Register the RMX.
— Power up the RMX.
— Modify the Default Management Network.
— Configure the Signaling Network Service.
— Configure the ISDN/PSTN Network Service.
4 Enable Ultra Secure Mode
5 Enable Secured Communication
— Purchase and Install the SSL/TLS certificate
— Modify the Management Network settings
— Create/Modify the relevant System Flags
6 Set System Configuration Flags
7 Enable Network Separation (RMX 2000)
8 Configure IVR Settings
9 Modify Default Login Banner Text (if required)
10 Rename the default POLYCOM user
11 Disable Inline AutoComplete Option in Web Browser
12 Configure an Inbound and Outbound Access List