Polycom RealPresence Collaboration Server (RMX)1500/2000/4000 Deployment Guide for Maximum Security Environments
1-14 Polycom, Inc.
3 Push the card into the slot until the ejector levers touch the front edge of the card cage.
4 Push the ejector levers to their fully closed position.
5 Tighten the captive screws on each side of the rear panel of the card, securing the RTM
ISDN card to the RMX.
A Software License is included with the ISDN card. This license must be registered as part of
the Product Registration and Product Activation process.
Mounting the RMX 2000 in a Rack
There are two methods for installing the RMX in a 19” rack:
• Using rack rail runners on the RMX 2000:
— Install the telescopic rail runners, as described in "Installing the Telescopic Rail
Runners on the Rack” on page 1-5.
— Mount the RMX 2000 on top of the rail runners.
— Fasten the RMX to the rack spacers using the flat head screw
(item 8) with
flat washer
(item 9) through the two holes in the RMX’s front mounting
brackets.
Ejector Lever
Captive Screw
Refer to Figure 1-2, "Detail of Front Rack Spacer Assembly (left rail runner is shown here) for all
RMX types” on page 1-8 for installation instructions.
To Next Page
Loading...
