Polycom 1500 - Advanced Commands

Polycom RealPresence Collaboration Server (RMX)1500/2000/4000 Deployment Guide for Maximum Security Environments
5-16 Polycom, Inc.
Advanced Commands
Table 5-3 Advanced Commands
Command Parameters Description Default
Advanced
Security
Mode
ENABLE This command puts the Gateway in
MAXIMUM security mode. Used by: CS
Available Since V5.7.2.0.7
The default of the
Gateway will be in
MINIMUM security
mode , but once the
user sets the
Gateway to
Maximum security
the only way to go
back to Standard
security is by the
‘Setting Factory
Defaults’
procedure.
Session
Inactivity
Enabled
Timeout
5-60
minutes
Sets the Inactivity timeout value. Web will
disconnect from GW if user is inactive for this
period of time.
Available Since V5.7.2
10 minutes
password
Change
Minimum
Time
1-30 days Sets the minimum number of days needed to
pass before User can change his/her own
password. This value is not valid for
administra-tors
Available Since V5.7.2
1 day
minimum
Password
Length
8-15 Sets the minimum length of a valid password
Available Since V5.7.2
15
upperCase
Minimum
1-2 Sets the minimum number of upper case
characters needed for a valid password.
Available Since V5.7.2
2
lowerCase
Minimum
1-2 Sets the minimum number of lower case
characters needed for a valid password.
Available Since V5.7.2
2
Numerical
Chars
Minimum
1-2 Sets the minimum number of numerical
characters needed for a valid password.
Available Since V5.7.2
2
Special
Chars
Minimum
1-2 Sets the minimum number of special
characters needed for a valid password.
Available Since V5.7.2
2