Chapter 1-First Time Installation and Configuration
Polycom, Inc. 1-35
12 Define the following parameters:
13 Click Next.
The PRI Settings dialog box opens.
Table 1-9 Fast Configuration Wizard – ISDN Service Settings
Field Description
Network Service
Name
Specify the service provider’s (carrier) name or any other name you
choose, using up to 20 characters. The Network Service Name
identifies the ISDN/PSTN Service to the system.
Default name: ISDN/PSTN Service
Note: This field is displayed in all ISDN/PSTN Network Properties tabs
and can contain character sets that use Unicode encoding.
Span Type Select the type of spans (ISDN/PSTN) lines, supplied by the service
provider, that are connected to the RMX. Each span can be defined as
a separate Network Service, or all the spans from the same carrier can
be defined as part of the same Network Service.
Select either:
• T1 (U.S. – 23 B channels + 1 D channel)
• E1 (Europe – 30 B channels + 1 D channel)
Default: T1
Note: Only one Span Type (E1 or T1) is supported on the RMX. If you
define the first span as type E1 all other spans that you may later
define must also be of type E1.
Service Type PRI is the only supported service type. It is automatically selected.
To Next Page
Loading...
