Application > VGL Setup > Prop Line Length
This menu determines how the position of the next graphic element is
determines based on the string that precedes it.
The position of the next graphic element will be
determined as if the font was monospaced (all
characters had the same specified width).
The position of the next graphic element will be
determined by the physical length of a text string (when
using a proportional spaced font).
Application > VGL Setup > Printer PI
This menu determines how the PI line is configured in the LP+ emulation.
The LP+ Emulation is configured with the PI line
disabled.
The LP+ Emulation is configured with the PI line
enabled.
Application > VGL Setup > Host PI
This menu determines how the host PI line for the parallel interface is
configured.
The host does not send PI signals.
The host sends PI signals. The Data Bit 8 configuration
option must be disabled to transmit the PI line to the
printer.
Application > VGL Setup > Max PI 16
This menu determines the range of a paper slew from the PI line.
A paper slew of 1-15 will move 1-15 lines. A paper slew
of 0 will always move 1 line.
A paper slew of 0-15 will move 1-16 lines.
To Next Page
Loading...
