Printronix T6000 - Host IO > IEEE-1284

174
Host IO > Centronics > AutoSW Timeout
This is the timeout value used for the current port to then check the other
selected port types for data to print. When the printer has not received data
from the host after a certain period of time, it needs to time out in order to
service the other ports. This submenu is only available when Host IO >
Control > Interface is set to Auto Switching.
Minimum
10 second
Maximum
60 seconds
Factory Default
10 seconds
Host IO > IEEE-1284
IMPORTANT This submenu will not be available unless the parallel option card is installed.
Host IO > IEEE-1284 > Buffer (Kbytes)
Same as Host IO > Centronics > Buffer (Kbytes).
Host IO > IEEE-1284 > Prime Signal
Same as Host IO > Centronics > Prime Signal.
Host IO > IEEE-1284 > TOF Action
Same as Host IO > Centronics > TOF Action.
Host IO > IEEE-1284 > Offline Process
Same as Host IO > Centronics > Offline Process.
Host IO > IEEE-1284 > Report Status
Same as Host IO > Centronics > Report Status.
Host IO > IEEE-1284 > Auto Trickle
Same as Host IO > Centronics > Auto Trickle.