Printronix T6000 - Application > ZGL SETUP; Application > TGL SETUP; Application > IGL SETUP; Application > STGL SETUP

139
Application > ZGL SETUP
Refer to the ZGL Programmer’s Reference Manual.
Application > TGL SETUP
Refer to the TGL Programmer’s Reference Manual.
Application > IGL SETUP
Refer to the IGL Programmer’s Reference Manual.
Application > STGL SETUP
Refer to the STGL Programmer’s Reference Manual.
Application > DGL SETUP
Refer to the DGL Programmer’s Reference Manual.
Application > IEGL SETUP
Refer to the IEGL Programmer’s Reference Manual.
Application > MGL SETUP
Refer to the MGL Programmer’s Reference Manual.
Application > LP+ SETUP
Application > LP+ Setup > Select CPI
This item selects the characters per inch (CPI) value.
Selections
10.0, 12.0, 13.3, 15.0, 17.1, and 20.0 CPI
Factory Default
10.0 CPI
Application > LP+ Setup > Select LPI
This is the number of lines to be printed per inch. For example, at 6 LPI there
is 1/6 inch from the top of one print line to the top of the next print line.
Selections
6.0, 8.0, 10.3 LPI
Factory Default
6.0 LPI