Printronix T6000 - Application > VGL Setup

126
Application > PGL Setup > Storage Select
Allows the user to map the parameter DISK to either SD (SD card) or FLASH
memory.
Disk=SD
Have the DISK command default to the SD card.
Disk=PCB
Flash
Have the DISK command default to the FLASH
memory.
Factory Default
Disk=SD
Application > VGL Setup
IMPORTANT The VGL Setup submenu will only be present when the Active IGP Emulation is
set to VGL. Otherwise, this menu will be replaced with the Active IGP Emulation
Setup menu.
Application > VGL Setup > Select SFCC
This option selects the Special Function Control Code. Run a configuration
printout to determine the currently selected SFCC.
Minimum
17
Maximum
255
Factory Default
caret ^ (decimal 94)
Application > VGL Setup > Power-up ^X
Determines if VGL is active at power-up or if all the data will be passed down
to the LP+ emulation for processing.
Disable
VGL is ready to process data.
Enable
VGL starts in ignore mode. The graphics mode ^PY is
set as the power-up default. All characters are ignored
until a ^A command is received.
Factory Default
Disable