Printronix T6000 - Application

93
Application
LP+, PGL, VGL Character Sets
The Character Sets for LP+, PGL, and VGL are chosen by Character Group and also a Character Set
within that group. The active Character Group will determine which collection of Character Sets will be
shown on the panel and available for selection. The LP+, PGL, and VGL each have their own Character
Group and Character Set selections. In the case of the LP+, every protocol (P-Series, Serial Matrix, etc.)
except for P-Series XQ will have its own selections as well.
The Character Group options and Character Set choices are described in this section. The default
Character Group “Standard Sets” is the legacy character set group and is unique to each emulation or
protocol. Therefore, it will be shown only in its respective section. The other groups are common and will
be described here. Any minor variations among the emulations will be highlighted here.
Character Group is selected within each emulation or protocol by their respective menu Application >
XXX Setup > Character Group, where XXX represents the emulation or protocol.
Application > XXX Setup > Character Group
This option selects the Character Set Group. Based on the group selected,
then the character set can be chosen with the menu following XXX Sets.
Standard Sets
A set of legacy sets via Standard Sets menu.
Arabic Sets
A set of Arabic sets via Arabic Sets menu.
Cyrillic Sets
A set of Cyrillic sets via Cyrillic Sets menu.
European Sets
A set of European sets via European Sets menu.
Greek Sets
A set of Greek sets via Greek Sets menu.
Hebrew Sets
A set of Hebrew sets via Hebrew Sets menu.
Turkish Sets
A set of Turkish sets via Turkish Sets menu.
UTF-8
Selects the UTF-8 character set.
Factory Default
Standard Sets
IMPORTANT
VGL does not have the UTF-8 character group.
Application > XXX Setup > Standard Sets
This is the legacy Character Group and is described in each XXX Setup
section.
Standard Sets
Unique
Unique
Factory Default
Unique