Printronix T6000 - Host IO > Centronics

170
Host IO > Centronics
IMPORTANT This submenu will not be available unless the parallel option card is installed.
Host IO > Centronics > Buffer (Kbytes)
This option configures the amount of memory allocated for the Ethernet
buffer incremented in 1 Kbyte increments.
Minimum
1
Maximum
16, 32, or 64
Factory Default
16 Kbytes
Host IO > Centronics > Prime Signal
This option determines how the printer will operate if the host asserts a
prime signal.
Disable
The printer will not reboot if the host asserts the Prime
Signal.
Enable
The printer will reboot if the host asserts the Prime
Signal.
Factory Default
Disable
Host IO > Centronics > TOF Action
This option determines if TOF is sought after a reboot of the printer due to
the host asserting a prime signal.
Reset
A form feed is performed before a warm start when the
prime signal is asserted from the host. This setting is
used only if the prime signal parameter is enabled.
Do Nothing
Nothing occurs before a warm start when the prime
signal is asserted from the host.
Factory Default
Reset