Printronix T6000 - European Union Conformity; Industry Canada Compliance Statement; Statement of CISPR 22 Compliance; Japanese VCCI Class a

309
European Union Conformity
This product is in compliance with the EU directives
for safety, EMC, ROHS, REACH, and WEEE. Please
refer to the Service and Support section at our web
site (www.PrintronixAutoID.com) for the most up to
Declarations of Conformity.
Printronix cannot accept responsibility for any failure to satisfy the protection requirements resulting from a
non-recommended modification of the product, including the fitting of non-Printronix option cards.
This product has been tested and found to comply with the limits for Class A Information Technology
Equipment according to European standard EN 55022. The limits for Class A equipment were derived for
commercial and industrial environments to provide reasonable protection against interference with
licensed communication devices.
Properly shielded and grounded cables and connectors must be used in order to reduce the potential for
causing interference to radio and TV communications and to other electrical or electronic equipment.
Printronix cannot accept responsibility for any interference caused by using other than recommended
cables and connectors.
Industry Canada Compliance Statement
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A conform á la norme NMB-003 du Canada.
Statement of CISPR 22 Compliance
Attention: This is a Class A Product. In a domestic environment this product may cause radio interference
in which case the user may be required to take adequate measures.
Japanese VCCI Class A
WARNING
This is a Class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.