Printronix T6000 - Media > Fault

68
Media > TOF > TOF Adjust Mode
This option enables use of the Media > TOF > TOF Adjust Dist.
Disable
The TOF Adjust Dist menu value will not be used.
Enable
The TOF Adjust Dist menu value will be used.
Factory Default
Disable
Media > TOF > TOF Adjust Dist
This option sets the distance from the Top Of Form (TOF) that is left blank
(unprinted) after a label has been removed in Tear-Off Strip mode. When this
mode is enabled the start position for printing can be adjusted in increments
of 0.01 inch.
This adjustment can be helpful if a die cut label sticks to the platen by means
of jagged edges created during a poor die cut label removal using the tear
bar. By controlling how much blank space there is from TOF, you can control
how much the media is called back after it is torn off.
Minimum
0.00 inches
Maximum
0.40 inches
Factory Default
Match Head DPI
IMPORTANT
Tear-Off Strip mode only
Media > Fault
Media > Fault > Label Missing
Allows the Label Taken Sensor to first detect the presence of a label at the
peel bar.
Disable
The printer does not generate a fault condition if a
missing label is encountered.
Enable
Peel-Off Handling: The printer generates a fault
condition if a missing label is encountered.
Factory Default
Enable